Lanner electronic FW-7870 Series Manual de usuario

FW-7870 Series 19” 1U Intel Pentium 4 Socket T Rackmount Network Security Platform User’s Manual

4 1.4 MB-X76 System Board MB-X76 is the system board bundled with the FW-7870 Network security platform. The succeeding sections list all MB-X76 rel

51.4.2 Jumper Settings and I/O Connector The onboard jumper settings and I/O connector of MB-X76 are custom-tailored to fit the FW-7870 functionali

6PSC1:24 Pin ATX Power Connector

7USBF1：USB Port #1 & #2 Connector 2x5 Pin 2.54mm

81.5 FW-7880 19” 1U Rackmount Firewall Mechanisms This section of the manual describes the mechanical and device nomenclature of FW-7880. 1.5.1 Fa

9 Console Port: via the console port cable, this connector attaches FW-7870 to the host PC.  LCM & Keypad Please reference the

101.5.3 Rear View Figure 6 – FW-7870 Rear View  Power Switch: Click the Power Switch , and the system will be power on. Faulty or improper

C h a p t e r 2 FW-7870 Hardware Installation Guide 2.1 Hardware Installation Guide - Removing the Top Cover Step 1 : Unscrew Five screws fro

- CPU Installation Step 1: Remove the fan cover screw (3 pcs) Step 2:

Step 4: Open load plate, (DO NOT TOUCH SOCKET CONTACTS) Step 5: Align notches with socket. Step 6: Close load plat

ii Copyright and Disclaimers © Copyright 2004 - Lanner Electronics Inc. All Rights Reserved The contents in this publication have been thoroughly ch

- System Memory - Figure 1: The DIMM slot has a notch, the DIMM memory module only fit in one direction. - Figure 2: Align the memory notch to t

Installing Hard Disk Drive: Figure 1: Put the Hard disk on the bracket, and screwing 4 screws.

Figure 4: Screwing the HDD bracket screws (4pcs).

Chapter 3 Award BIOS Setup 3.1 BIOS Setup Award‘s ROM BIOS provides a built-in Setup program that allows users to modify the basic system configu

<Esc> Main Menu - Quit and not save changes into CMOS Status Page Setup Menu and Option Page Setup Menu - Exit current page and return to Mai

3.2 Main Menu Once you enter the AwardBIOS™ CMOS Setup Utility, the Main Menu will appear on the screen. The Main Menu allows you to select fr

 Set Supervisor password Use this menu to set Supervisor Passwords.  Set User password Use this menu to set User Passwords.  Save & Exit S

detailed options IDE Channel 1 Master Options are in its sub menu Press <Enter> to enter the sub menu of detailed options IDE Channel 2 Master

Cylinder Min = 0 Max = 65535Set the number of cylinders for this hard disk. Head Min = 0 Max = 255 Set the number of read/write heads Precomp Min =

CPU L3 Cache: The option enables secondary cache memory. If enabled is selected, external cache memory is enabled. If disabled is selected, external

iii Safety Instructions The following information relates to the safety of installation and maintenance personnel. Read all instructions before atte

Boot Up Sequence. MPS Version Control For OS : An MP Platform interface standard that extends the performance of the existing PC/AT platform beyond

DRAM Date Integrity Mode : Select Non-ECC or ECC (error-correcting code), according to the type of installed DRAM. System BIOS Cacheable : Selectin

3.6 Integrated Peripherals On-Chip (Primary/Secondary) PCI IDE : The integrated peripheral controller contains an IDE interface with sup

controller and you have a USB keyboard. Onboard LAN Control : This setting controls the onboard LAN Controller. Enabled Enable Onboard H/W LAN func

SuperIO Device : Scroll to this item and press <Enter> to view the following screen: Power On Function/ KB Power ON Password/ Hot Key Po

IR Transmission Delay : When UART Mode is selected in IrDA or ASKIR mode, it allows you to enable / disable UR2 Duplex Mode (Half) : This field is a

3.7 Power Management Setup The Power Management Setup allows you to configure you system to most effectively save energy while operating in a mann

Suspend Mode When enabled and after the set time of system inactivity, all devices except the CPU will be shut off. Configuration options: Disabled

3.8 PnP/PCI Configuration This section describes configuring the PCI bus system. PCI, or Personal Computer Interconnect, is a system which allows

3.9 PC Health Status Throttling Temperature Detect CPU temperature automatically. FAN 1 / FAN 2 / FAN 3 Detect Fan1 / FAN2 speed status

iv Getting Technical Assistance Should you encounter questions or problems with your FW-7870, Lanner Electronics is ready to assist you within the g

3.11 Load Optimized Defaults When you press <Enter> on this item you get a confirmation dialog box with a message similar to: Load Optimized

ENTER PASSWORD: Type the password, up to eight characters in length, and press <Enter>. The password typed now will clear any prev

Pressing <Enter> on this item asks for confirmation: Save to CMOS and EXIT (Y/N)? Y Pressing “Y” stores the selections made in the me

3.14 Exit Without Saving Pressing <Enter> on this item asks for confirmation: Quit without saving (Y/N)? Y This allows you to exit Setup wit

Appendix A Power Supply Power Supply Specification AC Input Spec : VOLTAGE 90 ~ 264 VAC FULL RANGE Output Specifications Output Voltage Output Cur

Appendix B Watchdog Timer Introduction Most systems need to be self-reliant. It's not usually possible to wait for someone to reboot them if t

= 0 Disable = 1 Enable Bit 1-0 : Reserved CRF6 (Default 0x00) Watch Dog Timer Time-out value. Writing a non-zero value to this register causes the

A p p e n d i x C Console Redirection Console redirection allows you to maintain a system from a remote location by re-directing keyboard input and

A p p e n d i x D LCD Module and Key Pad For FW-7870 Purpose The purpose of this document is to provide installation information for the LCD module

2.Read_KeyPad(); =>This Function get the KeyPad number if user pressed key. =>Direct write function to your program. Ex. int a; a=Read_K

v Table of Contents Copyright and Disclaimers...ii

Terms and Conditions Date:2004.07.08 Warranty Policy 1. All products are warranted against defects in materials and workmanship for a period of t

RMA Service Request Form When requesting RMA service, please fill out this RMA Service Request Form. Without this form your RMA will be REJECTED!!!

PEXNSD01-040709 Version 1.0 Printed and published in Taiwan

vi 3.5 Advanced Chipset Features ... 24 3.6 Integrated Peripherals ...

1C h a p t e r 1 Getting Started 1.1 Introduction Figure 1 – FW-7870 Outlook The FW-7870 is a 1U rackmount network security solution targeting the

21.2 Technical Specifications Model Name FW-7870 SBC SBC MB-X76A CPU Socket T(LGA 775) for Intel Pentium 4 Processor Chipset Intel 915GV/Intel i828

31.3 Packing Contents Carefully unpack your package and make sure that you have the following items.  FW-7870 Network security Platform  Console